Magnolia · ice makers
Ice Maker Repair in Magnolia, Seattle
Built-in ice maker quit in a Magnolia kitchen? We test the fill valve, the module and the freezer temperature before we name the part.
Trouble in the sealed system (a coil leaking refrigerant, a compressor that refuses to start) gets fixed in your kitchen too, by our EPA 608 Universal certified crew. The fridge never rides in a truck.
- The repair cost in writing before we start
- Authorized for LG and Whirlpool
- Open all seven days, 8 AM–7 PM
- Washington license for appliance repair
- Authorized for LG and Whirlpool
- EPA 608 Universal refrigerant card
- Sealed systems fixed in the kitchen
- Seven days, 8 AM–7 PM
Ice makers in Magnolia
What we see on ice maker calls in Magnolia
Built-in refrigerators in Magnolia homes are often fed by a long copper line from the basement. Older saddle valves on that line partly close over time and starve the ice maker. We check the supply first, then the inlet valve and the module.
Most ice makers stop for one of three reasons: no water reaches the mold, the mold does not eject, or the freezer runs too warm to finish a batch. We check the water inlet valve and the fill tube, test the ice maker module and its thermostat, and read the freezer temperature before deciding what to replace.
No ice at all
A fill tube frozen solid, a supply valve left closed, a dead water valve, or a module that quit cycling.
Small or hollow cubes
Weak pressure at the valve, an overdue filter, or a saddle valve only partly open.
Ice clumped in the bin
Cubes melting and refreezing because the freezer runs warm, or a dispenser flap that stays open.
Dispenser jams
An auger motor that stalls, or cubes fused around the auger.
How a visit goes
From your call to a working machine
- 1
Tell us what is wrong
Ring us or fill in the booking card: which machine, what it does, your ZIP. A person calls back to agree on a time, any of the seven days, 8 AM–7 PM.
- 2
A meter, not a hunch
At your door the technician confirms power first, runs a cycle, then takes readings on the parts that fit the symptom. The diagnosis comes from numbers on the meter.
- 3
A cost you can hold
Before a screw is turned, the repair cost is written out for you. Say yes, and the visit charge is swallowed by that figure. Say no, and only the trip gets billed, with our notes left in your hands.
- 4
Fixed, and on paper
Igniters, pumps, fuses and valves ride along in the van, which lets plenty of jobs close out in a single trip. Parts we need to order get a return date pinned down before we leave. Your invoice lists the warranty in plain terms.
Around the dial
What we repair in Magnolia, mark by mark
Seven marks, one for each kind of job we take on. Tap a mark or let the dial turn.
Mark 1 of 7
Ice makers
No cubes, hollow cubes, or a fill line frozen in place.
Ice Maker Repair in Magnolia →Around Magnolia
Where Magnolia appliances live
Magnolia homes are mostly single-family, from 1920s Tudors near W McGraw Street to midcentury ramblers on the bluff. The peninsula has only a few ways in, so we plan Magnolia visits around bridge traffic.
FAQ
Ice makers in Magnolia: questions
Is Magnolia too far out for a same-day visit?
No. It takes some planning around the few roads onto the peninsula, but same-day visits there are routine when the morning schedule allows.
How long before a repaired ice maker fills the bin?
The first batch usually drops within several hours, and the bin takes close to a day to fill, depending on how cold the freezer runs.
Do you fix undercounter ice machines?
Yes, home undercounter units, including clear-ice models with their own pump and drain.
Why does my ice taste stale?
Old ice soaks up freezer smells. Dump the bin, put in a fresh filter, and seal open food. If the taste stays, the filter housing or the water line may need attention.
Ice Maker Repair in Magnolia, any day
Describe the trouble and we ring back to fix a time and quote the visit charge. The repair figure goes on paper, and nothing gets unscrewed until you have read it and said yes.