Ballard · ice makers

Ice Maker Repair in Ballard, Seattle

No ice from the fridge in your Ballard townhouse? We find out whether it is the water, the module or the freezer, then fix it on the spot if we carry the part.

Trouble in the sealed system (a coil leaking refrigerant, a compressor that refuses to start) gets fixed in your kitchen too, by our EPA 608 Universal certified crew. The fridge never rides in a truck.

  • The repair cost in writing before we start
  • Authorized for LG and Whirlpool
  • Open all seven days, 8 AM–7 PM
Illustration of an ice maker tray dropping cubes into the ice bin
Water supply first, then the ice maker itself

Book a repair visit

Three short steps. We call back to confirm the arrival window and to name the diagnostic fee, which becomes part of the repair price if you go ahead.

Which appliance
The problem
Contact

We use these details only to schedule your visit.

Ice makers in Ballard

What we see on ice maker calls in Ballard

In Ballard townhouses the fridge water line often runs a long way from the main, and a partly closed valve or a kinked line behind the fridge starves the ice maker. Small hollow cubes are the first sign. We check pressure at the valve and the filter before replacing anything.

Most ice makers stop for one of three reasons: no water reaches the mold, the mold does not eject, or the freezer runs too warm to finish a batch. We check the water inlet valve and the fill tube, test the ice maker module and its thermostat, and read the freezer temperature before deciding what to replace.

  1. Undercounter unit stopped

    A dirty condenser, a failed water pump, or a clogged drain on clear-ice models.

  2. No ice at all

    A fill tube frozen solid, a supply valve left closed, a dead water valve, or a module that quit cycling.

  3. Small or hollow cubes

    Weak pressure at the valve, an overdue filter, or a saddle valve only partly open.

  4. Ice clumped in the bin

    Cubes melting and refreezing because the freezer runs warm, or a dispenser flap that stays open.

How a visit goes

From your call to a working machine

  1. 1

    Tell us what is wrong

    Ring us or fill in the booking card: which machine, what it does, your ZIP. A person calls back to agree on a time, any of the seven days, 8 AM–7 PM.

  2. 2

    A meter, not a hunch

    At your door the technician confirms power first, runs a cycle, then takes readings on the parts that fit the symptom. The diagnosis comes from numbers on the meter.

  3. 3

    A cost you can hold

    Before a screw is turned, the repair cost is written out for you. Say yes, and the visit charge is swallowed by that figure. Say no, and only the trip gets billed, with our notes left in your hands.

  4. 4

    Fixed, and on paper

    Igniters, pumps, fuses and valves ride along in the van, which lets plenty of jobs close out in a single trip. Parts we need to order get a return date pinned down before we leave. Your invoice lists the warranty in plain terms.

Around the dial

What we repair in Ballard, mark by mark

Seven marks, one for each kind of job we take on. Tap a mark or let the dial turn.

Illustration of an ice maker tray dropping cubes into the ice binIllustration of a French-door refrigerator with a thermometer showing the fresh-food side running warmIllustration of a front-load washer with water and suds behind the door glassIllustration of a clothes dryer with a tumbling load, heat waves and the vent hoseIllustration of an open dishwasher with plates and glasses on the racksIllustration of a kitchen range with gas flames on the cooktop and a glowing oven windowIllustration of a technician’s meter with test leads and a written checklist

Mark 1 of 7

Ice makers

No cubes, hollow cubes, or a fill line frozen in place.

Ice Maker Repair in Ballard →
1 / 7

Around Ballard

Where Ballard appliances live

Ballard homes run from century-old bungalows with basement laundries to new townhouses with the washer and dryer on the top floor. Parking tightens near Ballard Avenue in the evening, so earlier windows there tend to run smoother.

FAQ

Ice makers in Ballard: questions

Do you have visits in Ballard on Saturdays and Sundays?

Yes. We book Ballard visits on all seven days, 8 AM–7 PM, and same-day openings there come up often.

Ice maker leaking: should it be off when you get there?

If it is dripping inside the freezer or on the floor, yes: flip the ice maker switch off and keep the fridge itself running.

How long before a repaired ice maker fills the bin?

The first batch usually drops within several hours, and the bin takes close to a day to fill, depending on how cold the freezer runs.

Do you fix undercounter ice machines?

Yes, home undercounter units, including clear-ice models with their own pump and drain.

Ice Maker Repair in Ballard, any day

Describe the trouble and we ring back to fix a time and quote the visit charge. The repair figure goes on paper, and nothing gets unscrewed until you have read it and said yes.

CallBook a visit