Ballard · refrigerators

Refrigerator Repair in Ballard, Seattle

Fridge running warm in a Ballard bungalow kitchen or a new townhouse on NW 56th? We come to you, find the fault with a meter, and fix it where it stands.

Trouble in the sealed system (a coil leaking refrigerant, a compressor that refuses to start) gets fixed in your kitchen too, by our EPA 608 Universal certified crew. The fridge never rides in a truck.

  • The repair cost in writing before we start
  • Authorized for LG and Whirlpool
  • Open all seven days, 8 AM–7 PM
Illustration of a French-door refrigerator with a thermometer showing the fresh-food side running warm
A warm fridge starts with a thermometer reading, not a guess

Book a repair visit

Three short steps. We call back to confirm the arrival window and to name the diagnostic fee, which becomes part of the repair price if you go ahead.

Which appliance
The problem
Contact

We use these details only to schedule your visit.

Refrigerators in Ballard

What we see on refrigerator calls in Ballard

Old Ballard kitchens were small, so many fridges sit in a tight alcove with little room to breathe at the back. Dust on the condenser and poor airflow make the compressor run long, and the fresh-food side drifts warm first. In the newer townhouses, French-door models and their ice makers make up most of our refrigerator calls.

Most refrigerator calls in the city come down to air, ice and a few small parts. A frozen evaporator coil blocks the cold air meant for the fresh-food compartment. When a defrost heater or its thermostat quits, frost builds until the fan blade scrapes it. A start relay clicks every few minutes while the compressor stays silent. A meter and a thermometer tell us which part is to blame before anything gets ordered, and you get the number in ink first.

  1. Warm up top, cold below

    Most often a frozen evaporator coil or a stalled fan behind the freezer panel. The cold is there; it just cannot travel.

  2. Frost on the rear panel

    Something in the defrost circuit, heater, sensor or control, has quit. Left alone, ice spreads until no air moves.

  3. Puddles below the crispers

    The defrost drain has iced up or clogged, and melt water that should reach the pan underneath ends up inside the fridge.

  4. Clicking, then silence

    A failing start relay or overload, sometimes a compressor that will not start. We test which one before anything is ordered.

How a visit goes

From your call to a working machine

  1. 1

    Tell us what is wrong

    Ring us or fill in the booking card: which machine, what it does, your ZIP. A person calls back to agree on a time, any of the seven days, 8 AM–7 PM.

  2. 2

    A meter, not a hunch

    At your door the technician confirms power first, runs a cycle, then takes readings on the parts that fit the symptom. The diagnosis comes from numbers on the meter.

  3. 3

    A cost you can hold

    Before a screw is turned, the repair cost is written out for you. Say yes, and the visit charge is swallowed by that figure. Say no, and only the trip gets billed, with our notes left in your hands.

  4. 4

    Fixed, and on paper

    Igniters, pumps, fuses and valves ride along in the van, which lets plenty of jobs close out in a single trip. Parts we need to order get a return date pinned down before we leave. Your invoice lists the warranty in plain terms.

Around the dial

What we repair in Ballard, mark by mark

Seven marks, one for each kind of job we take on. Tap a mark or let the dial turn.

Illustration of a French-door refrigerator with a thermometer showing the fresh-food side running warmIllustration of a front-load washer with water and suds behind the door glassIllustration of a clothes dryer with a tumbling load, heat waves and the vent hoseIllustration of an open dishwasher with plates and glasses on the racksIllustration of a kitchen range with gas flames on the cooktop and a glowing oven windowIllustration of an ice maker tray dropping cubes into the ice binIllustration of a technician’s meter with test leads and a written checklist

Mark 1 of 7

Refrigerators

Milk going warm, frost climbing the back wall, a drain iced over.

Refrigerator Repair in Ballard →
1 / 7

Around Ballard

Where Ballard appliances live

Ballard homes run from century-old bungalows with basement laundries to new townhouses with the washer and dryer on the top floor. Parking tightens near Ballard Avenue in the evening, so earlier windows there tend to run smoother.

FAQ

Refrigerators in Ballard: questions

Do you have visits in Ballard on Saturdays and Sundays?

Yes. We book Ballard visits on all seven days, 8 AM–7 PM, and same-day openings there come up often.

Can you fix the sealed system without taking the fridge away?

Yes. Compressor replacement, leak repair and the recharge are done in your home by an EPA 608 Universal certified technician. On the first visit we tell you whether that work is worth it on a fridge of that age.

My fridge is an LG or a Whirlpool still under warranty. Can you take it?

Yes. Our LG and Whirlpool authorization reaches Maytag, KitchenAid, JennAir and Amana as well. Covered repairs on those makes are handled by us; have the purchase date ready when we call back.

Do I unplug a warm fridge while I wait?

No, keep it plugged in. The exceptions: water reaching a floor that could be damaged, or frost jamming the fan. Otherwise the technician wants to catch the fault in the act.

Refrigerator Repair in Ballard, any day

Describe the trouble and we ring back to fix a time and quote the visit charge. The repair figure goes on paper, and nothing gets unscrewed until you have read it and said yes.

CallBook a visit